Instructions - GLASSGUARD™ RAIN REPELLENT NANOCOAT

IMPORTANT: We recommend wearing gloves when using this product. Ensure that the area being treated is well-ventilated. Do not store the product in direct sunlight. Store it in its sealed container with the trigger switch off and keep it away from children. In case of eye contact, wash out immediately with water. Do not swallow or inhale. Seek medical advice if necessary. For use on glass surfaces only.

 

STEP 1: PREPARING THE SURFACE

Unscrew the pre-cleaner bottle cap and fill the bottle with warm water. (Each bottle has an eco-friendly cleaner tablet inside that will dissolve to create the pre-cleaner liquid). Clean the glass using the pre-cleaner solution provided or an alcohol-based cleaner. Dry the glass and ensure that there is no residue that might interfere with the rain repellent treatment.

 

STEP 2: APPLYING THE RAIN REPELLENT

Unscrew the pre-cleaner bottle cap and fill the bottle with warm water. (Each bottle has an eco-friendly cleaner tablet inside that will dissolve to create the pre-cleaner liquid). Clean the glass using the pre-cleaner solution provided or an alcohol-based cleaner. Dry the glass and ensure that there is no residue that might interfere with the rain repellent treatment.

 

STEP 3: POST-APPLICATION

If you see "grit," "residue," or "swirly marks" on the glass, this is just an excess of rain repellent on the glass. After about 5-10 minutes, use a damp cloth to polish the item and remove all the grit/residue from the item. Then, using a dry cloth, wipe all the wet grit/residue off the item. You may have to repeat this process a few times. Allow at least 24 hours for the rain repellent to completely dry, and try not to wet the glass during this time.

 

IN CASE OF FAILED APPLICATION

If you have applied the nanocoat incorrectly and need to remove it, use a strong alcohol-based cleaner or methylated spirits (found at most hardware stores or supermarkets). Apply the cleaner to a microfiber cloth and wipe the nanocoat from the surface. Once the surface is clean, you can reapply the nanocoat following the instructions above carefully.