Instructions - GLASSGUARD™ NANOCOAT FOR TILES & GROUT

 IMPORTANT: We recommend wearing gloves while using this product. Ensure that the treated area is well-ventilated. Do not store the product in direct sunlight. Keep it in its sealed container with the trigger switch off and away from children. In case of eye contact, wash out immediately with water. Do not swallow or inhale. Seek medical advice if necessary. This product is for use on tiles & grout surfaces only

 

STEP 1: PREPARING THE SURFACE

Make sure the surface is as clean as possible. If there are stains or mineral buildup, we recommend restoring the surface to a 'new state'. Once the surface is restored as much as possible, clean the surface using any basic or alcohol-based cleaner and give it a good rinse with water. Dry the surface and make sure it is free of any residue that might interfere with the Nanocoat treatment.

 

STEP 2: APPLYING THE NANOCOAT

Divide the surface into 1 square meter or 3 square feet sections at a time. Spray the Nanocoat across the surface, using only 2-3 sprays for each section. With a dry microfiber cloth, evenly spread the Nanocoat in circular motions until it is completely dry. This process may take up to 1 minute. Once dry, you can move on to treating the next section of the surface. Repeat this process until you have treated the entire area.

 

STEP 3: POST-APPLICATION

You may notice the presence of 'grit', residue, or swirling marks on the surface. This is normal and indicates an excess of Nanocoat on the surface. After approximately 5-10 minutes, use a damp cloth to polish the surface and remove all the grit/residue. Then, using a dry cloth, wipe off any remaining wet grit/residue from the surface. You may need to repeat this process a few times, but once complete, you should have a clear, clean surface with the Nanocoat applied. Allow at least 24 hours for the Nanocoat to completely dry, and avoid wetting the surface during this time.

 

 

IN CASE OF FAILED APPLICATION

If you have applied the Nanocoat incorrectly and notice the presence of 'grit', residue, or swirling marks, you can rectify the situation. Use a strong alcohol-based cleaner or ethylated spirits (available at most hardware stores or supermarkets) to remove the Nanocoat. Ensure thorough cleaning of the surface. Afterward, you can reapply the Nanocoat by following the instructions provided above carefully.