Instructions - GLASSGUARD™ NANOCOAT FOR CAR

 IMPORTANT: We recommend wearing gloves while using this product. Ensure that the treated area is well-ventilated. Do not store the product in direct sunlight. Keep it in its sealed container with the trigger switch off and away from children. In case of eye contact, wash out immediately with water. Do not swallow or inhale. Seek medical advice if necessary. This product is for use on ceramic surfaces only

 

STEP 1: PREPARING THE CAR

Ensure that the car is as clean as possible. Dry the car and ensure that there is no residue that might interfere with the nanocoat treatment.

STEP 2: APPLYING THE NANOCOAT

Apply the nanocoat to the car one panel at a time. Spray the nanocoat across one panel, use a dry microfiber cloth to spread it around until it is completely dry, and then move on to the next panel. Repeat the process until you have treated the entire automobile.

STEP 3: POST-APPLICATION

If you see "grit," "residue," or "swirly marks" on the car. This is normal, as it is just an excess of nanocoat on the car. After about 5-10 minutes, use a damp cloth to polish the car and remove all the grit/residue from the car. Then, using a dry cloth, wipe all the wet grit/residue off the car. You may have to repeat this process a few times, but once complete, you should have a clear, clean car with the nanocoat applied. Allow at least 24 hours for the nanocoat to completely dry, and try not to wet the car during this time

 

 

IN CASE OF FAILED APPLICATION

If you have applied the nanocoat incorrectly and need to remove it, use a strong alcohol-based cleaner or methylated spirits (found at most hardware stores or supermarkets). Apply the cleaner to a microfiber cloth and wipe the nanocoat from the surface. Once the surface is clean, you can reapply the nanocoat following the instructions above carefully